ok rather start a new thread so that we dont hijack another into oblivion
Is it possible(safe & feasible) to cast a heavy sinker using a large multiplier loaded with braid topshot and then slide a bait down said topshot?Something that has been discussed but tried by very few. So I thought I'd give it a go!
tackle used in the testShimano Trinidad DC30
L&F Sharky Standard
100lb XX Viper braid
1.3mm windon leader
8oz sinker
The castingThe viper braid is pretty soft which is a disadvantage because it doesnt lift up by itself when it comes time to leave the spool on a cast, it wants to stay curled up until it gets pulled forward by the sinker. I think 30lb fireline(about 50lbs linear breaking strength) or even better fireline tracer braid which is the only braid I know of that has been optimized for casting with a multiplier, may be better options. I am going to put 65lb JBLO back onto the DC now that tarpon season is over.
Its a lot easier to get an overwind with the soft braid, but the overwinds I got didnt cut deep. Pulled out easily. I only got an overwind once I really started pushing it otherwise the casts were uneventful.
Good distance, a good 100m without much effort and a thickish leader. I had to set the digital control pretty high when using the braid, but I was still getting a decent distance, similar to what I was getting with 0.55 seagrand. With that high setting I didnt put my hand near the spool for fear of losing a thumb
verdict - well, with a DC you can get away with using soft braid, but I reckon 30lb fireline would work well... You could use the 50lb but then you would lose the distance advantage due to the thickness.
Slidingwow! feels weird! you're only able to wiggle your tip about 6 inches from no tension to tight. It goes down not too fast so you have to shake a bit longer. My slide did get all the way down because I got epically stuck once I wanted to pull out and was pulling like a madman to get unstuck, so obviously my hooks and fouled on the rocks... eventually the 80lb dacron broke where it went single between the leader and the loop. At least I know my windons work! Thats another reason for using braid under 50lb I think, easier to break off, rather use a bimini than a stitch to weaken it a bit...
verdict - it works, just slide a bit longer. pop your sinker if you're not sure if its all the way down. Reckon its much easier to get the bait down with a non-hmg cos its wigglier. Make sure your sinker sits VAS, a long boom is the answer.
Why use braid?In my opinion you wont get burnt off on braid as you would on nylon.
Its thinner so with a reel that can handle it (DC, talented caster) you should get much better distance.
Its super direct so those headshakes and wing flaps will make fighting that nunu all the more adrenalin pumping!
Those are my findings, hopefully me sharing this will encourage you to try it for yourself :)
I slid the smallest shad i could find (+-40cm) but no takers