Author Topic: Fishing rod broken  (Read 2305 times)

0 Members and 1 Guest are viewing this topic.

Offline Nishon

  • Member
  • *
  • Posts: 13
  • Cred: 0
  • Gender: Male
  • Location: Stanger
Fishing rod broken
« on: December 28, 2019, 07:34:17 PM »
Howzit guys


I had a new rod break while casting a 3 ounce weight and i cannot figure out how that could happen.


The rod is the new Okuma blue series spinning rod in 12 foot with a 1-4 ounce casting weight. It was the second time i used it since brand new.


The rod was paired with a daiwa bg4000 reel and 20 pound braid. It was fine during the first 4 casts and on the fifth cast it snapped and went in with the line and i had to retrieve that piece with my trace.


The rod was transported in the rod tube it comes in and i didnt drop or knock it an any way and i can say with confidence that i didnt do anything that could have caused any damage to the rod.


The rod piece that broke was between the tip and the guide below the tip, it broke centre if both those guides. I have a Loomis archipelago which i use 3 ounce weights and have never had any issues no matter hiw hard i throw. Can anybody shed some light on what could have went wrong?


I took the rod back to Basil Manning in Ballito and they were really helpful and said they would send it back to suppliers. I also requested if it was a fault with the rod and if they replaced it, i would take the same type of rod but in 4-6 ounce and pay the difference as im really reluctant to use the 1-4 ounce in that range.


The tip on the Okuma is really thin compared to the loomis although they both same casting range and both HMG rods.
« Last Edit: December 29, 2019, 08:59:18 AM by John F »

Offline Nishon

  • Member
  • *
  • Posts: 13
  • Cred: 0
  • Gender: Male
  • Location: Stanger
Re: Fishing rod broken
« Reply #1 on: December 28, 2019, 08:47:41 PM »
Sorry guys i meant to say it the Makaira blue spinning rod. Its the new range. My mistake.
« Last Edit: December 29, 2019, 10:21:59 AM by John F »

Offline fishatic

  • Ultimate member
  • ***
  • Posts: 500
  • Cred: 14
  • Gender: Male
  • Location: Randpark Ridge, Johannesburg
Re: Fishing rod broken
« Reply #2 on: December 29, 2019, 03:45:56 PM »
Rod could have been damaged at the factory, in transit to SA or even inadvertently in the shop.
It happens.
Sensation keep spare rod sections (unlike some others) and they are normally good about support

Offline Nishon

  • Member
  • *
  • Posts: 13
  • Cred: 0
  • Gender: Male
  • Location: Stanger
Re: Fishing rod broken
« Reply #3 on: December 29, 2019, 05:36:02 PM »
Thanks Brandon.Will give them a call when they re-open after holidays.

Offline Muzwaid Karim

  • Member
  • *
  • Posts: 7
  • Cred: 0
  • Gender: Male
  • ONN DAD!!!
  • Location: Point Waterfront
Re: Fishing rod broken
« Reply #4 on: January 09, 2020, 08:03:18 PM »
Hi Nishon
The line could have accidentally wrapped around the front guide and could have broken off whilst casting


Offline Nishon

  • Member
  • *
  • Posts: 13
  • Cred: 0
  • Gender: Male
  • Location: Stanger
Re: Fishing rod broken
« Reply #5 on: January 13, 2020, 09:09:11 PM »
It wasnt wrapped around the guide.I have a habit of tossing the sinker in front of me and reeling it back in after baiting up.That way you can notice if the line is wrapped around the rod tip.I get what you are saying but it wasnt the case of what happen.

 

SimplePortal 2.3.7 © 2008-2026, SimplePortal