0 Members and 1 Guest are viewing this topic.
And can anyone shead light on why braid to mono gives so many problems, we cast biminis, catpaws and fig 8's with mono to mono, but even tiny knots cause problems with braid.
Nice post Vandit. With regards to the video, I would suspect those beads are performing much like mono would, whereas braid would go straight over the rim with little or no 'loop' above it. I've always suspected the difference in suppleness between the line types being the main problem, which is why even an fg is not foolproof. Does anyone using braid as mainline on a multiplier with a fluoro/mono leader have any feedback. Can bigger knots be used? This should give us an indication as to what extent the coils on a grinder are responsible for the problems.
Hi again Vandit, I found this video https://youtu.be/YZ1-4DVLSZ0, as an explanation for the wave effect with the beads. It suggests that a change in flexibility rather than mass is the reason for the problem, in other words the properties of the material rather than its mass is the problem. To visualize - if you double braid and lay the two lines next to each other and leave them alone, they will remain next to each other, and the loop formed will be small, where with mono the two lines would separate leaving a larger loop. This being a result of the lines ability or lack thereof to change direction. In other words a chain followed by piano wire may maintain the wave, even though the wire has less mass than a rope.
Eish, men..interesting subject. No offence, but I think some of you guys need to get down to a lower altitude where the salt water is. It appears that :sailf:the high altitude, fresh water and the lack of fishing is doing something strange to you guys up there ?
On the bright side Ill get my fix starting tomorrow with a ten day trip to Mpame Transkei.
Vandit! Once solution 1 and 2 are in place, solution 3 is an issue. The expense (not such a big problem), but for eg with 30 lbs line, the leader would be at least .50 after the taper to ensure it breaks beyond 30lbs with some change, I think our mass and stiffness priblem will still exist. I was thinking taking care of the problem on the braid side of the join, by inserting a length of mono. It would need to be at least the length as the distance from first guide to the reel, and would need to twist (fairly big twists) around the braid. It would also if possible not take pressure when pulling hard (ie not act a a double line as in biminis etc, but merely take care of the huge and sudden loss of mass and stiffness.