Author Topic: Chumming the area you are fishing in when In-ed fishing from the shore  (Read 5080 times)

0 Members and 1 Guest are viewing this topic.

Offline Lichia amia

  • Retired
  • *
  • Posts: 0
  • Cred: 0
  • Gender: Male
On our recent Vidal trip Mike “the Mongoose” Pike used some of his left over bait to chum the area we where fishing in.  We had a couple of good takes and a fish was landed . What are your thoughts on chumming and how would you go about it. Personaly I was thinking 1 to 2 kgs chopped Pilly mixed with Ancovy oil drifted out ? :dunno:

Offline Homie

  • Retired
  • *
  • Posts: 0
  • Cred: 0
  • Gender: Male
Re: Chumming the area you are fishing in when In-ed fishing from the shore
« Reply #1 on: November 23, 2010, 11:56:06 AM »
Craig,
another good idea (pity I didnt have this brain fart at Vidal) is to take all leftover bait etc mix with sand and put into a sack in the water. will allow the scent to drift out for much longer !

Offline REEFMAN

  • Ultimate Champ
  • ****
  • Posts: 9768
  • Cred: 769
  • Gender: Male
  • Location: Jozi
Re: Chumming the area you are fishing in when In-ed fishing from the shore
« Reply #2 on: November 23, 2010, 12:04:40 PM »
Make sure you find a 'Rip' out to sea where you release it.
Another idea is when you have a dead low tide, dig a hole, bury the chum about 20cm deep. Mark the spot and come fish for edibles on the High tide..!

Offline super_daav

  • Ultimate member
  • ***
  • Posts: 855
  • Cred: 74
  • Gender: Male
  • Lower Zambezi 2009
  • Location: Durban, KZN
Re: Chumming the area you are fishing in when In-ed fishing from the shore
« Reply #3 on: November 23, 2010, 12:13:54 PM »
I shall never underestimate your sneakiness again, Reefs... Great ideas!
Kingfisher.co.za
Official Daiwa agent

Offline SAfish

  • Angler of the Month - April 2015
  • Ultimate Champ
  • ****
  • Posts: 4238
  • Cred: 137
  • Gender: Male
  • Location: Knysna, South Africa
Re: Chumming the area you are fishing in when In-ed fishing from the shore
« Reply #4 on: November 23, 2010, 12:22:03 PM »
Here is an idea:
To make a slow release chum you can freeze your left over bait in a container with a bio-degradable rope attached to it. Make a loop in it and then insert it into the chum before freezing. Attach a weight (rock) to it to keep it on the bottom. You can either slide it out or throw it in.  :dunno: Will it work??

Offline Garrick

  • Ultimate member
  • ***
  • Posts: 320
  • Cred: 30
  • Gender: Male
  • The Gentleman of the Sea
  • Location: Centurion
Re: Chumming the area you are fishing in when In-ed fishing from the shore
« Reply #5 on: November 23, 2010, 12:42:18 PM »
Hiya chappies

What I do sometimes (when the fishing is slow)and especially at night is get meself a nice couta and cut him up while still having him in one whole piece.I take it which is attched to a rod stand and place it at the water's edge.Just where the water is going to break on it and slowly break it up and take the scent back.As the tide starts comming in i keep moving the bait backwards but at the same time making sure that it gets broken up nicely by the water.This creates a nice slick as the couta discharges a lot of oils and together with all the small pieces of flesh in the water.Never went wrong when this was done.
Today I would rather take the same couta and put him on the braai. :hehe:

cheers

Garrick
Winners don't quit and Quitters don't win.

Offline MIKE PIKE

  • Ultimate Hero
  • *****
  • Posts: 3886
  • Cred: 196
  • Gender: Male
Re: Chumming the area you are fishing in when In-ed fishing from the shore
« Reply #6 on: November 23, 2010, 01:23:17 PM »
On our recent Vidal trip Mike “the Mongoose” Pike used some of his left over bait to chum the area we where fishing in.  We had a couple of good takes and a fish was landed . What are your thoughts on chumming and how would you go about it. Personaly I was thinking 1 to 2 kgs chopped Pilly mixed with Ancovy oil drifted out ? :dunno:
True , chumming the water does seem to liven up the waters a bit i normally take a pile of 2-3 day old bait , from prawns to bits of redeye, sards, chokka whatever l can lay my hands on bait wise ,chop it all up in small pieces and especially the heads of sards and red eyes ,plenty oil/blood and juices in there and chuck it all in bait bucket with some water for about 15  to 20 mins and then as tide starts pushing throw some out in the surf zone, keep repeating every 10 minutes or so till bucket starts getting empty... like Tony mentioned check for rips and currents that can drag the slick line out further also check which way the current and sea is moving , you dont want to be chumming the area and 10 anglers to the left or right of you are getting all the pulls and you none  for the effort youve put in.

Offline Lichia amia

  • Retired
  • *
  • Posts: 0
  • Cred: 0
  • Gender: Male
Re: Chumming the area you are fishing in when In-ed fishing from the shore
« Reply #7 on: November 23, 2010, 01:38:34 PM »
Thanks all for your input  :uarocks

Offline Garrick

  • Ultimate member
  • ***
  • Posts: 320
  • Cred: 30
  • Gender: Male
  • The Gentleman of the Sea
  • Location: Centurion
Re: Chumming the area you are fishing in when In-ed fishing from the shore
« Reply #8 on: November 23, 2010, 02:37:39 PM »
I used to do the exact same what Mike has mentioned in the good old days when the estuary in St Lucia was open.Also one had to see which way the current is flowing.The one day I got caught out and ended up chumming the area on Mapies side and the okes smashed the grunters while we on the St Lucia side sat with no luck.
Winners don't quit and Quitters don't win.

Offline Kumz

  • Retired
  • *
  • Posts: 0
  • Cred: 0
  • Gender: Male
Re: Chumming the area you are fishing in when In-ed fishing from the shore
« Reply #9 on: November 23, 2010, 06:15:16 PM »
Personally ...
to chum the area  ..i wud use  5kg box of Sards ...Some old bait etc & a bottle or 2 of Anchovy oil ...
Best way woudl be to liquidise all the bait & oil together

Put them in 2lt bottles & freeze them ...


Once at water's edge .. cut up bottles ..Dig a hole at low tide on waters edge & bury the frozen blocks ..
I have also Taken 5 lt buckets & did the same thing ....


Use it ...dont use it ... w;k
 

Offline MIKE PIKE

  • Ultimate Hero
  • *****
  • Posts: 3886
  • Cred: 196
  • Gender: Male
Re: Chumming the area you are fishing in when In-ed fishing from the shore
« Reply #10 on: November 23, 2010, 08:33:15 PM »
Another method is to take all the old bait and run it thru those old style hand driven mincer's and then freeze in a plastic bag ,then when at the beach again emty the bag into a orange bag and stake down on the beach at a low tide ,as it unfreezes all the scents and bits and pieces get washed out the mesh and bingo ...tight lines , just remember to collect the bag when you leave the spot.

Offline WalkersKiller

  • Fish The Sea | Fish The Fly | Gareth Roocroft
  • Ultimate Champ
  • ****
  • Posts: 7417
  • Cred: 366
  • Gender: Male
  • Conservation First!
  • Location: Edenvale, Gauteng
Re: Chumming the area you are fishing in when In-ed fishing from the shore
« Reply #11 on: November 23, 2010, 10:00:41 PM »
Awesome info guys thanks for sharing...

 

SimplePortal 2.3.7 © 2008-2026, SimplePortal