ULTIMATE ANGLING - the Ultimate SA Fishing website

General Angling Topics => Shore Angling => Topic started by: Lenny on September 09, 2011, 03:10:59 PM

Title: CONE sinker TIP
Post by: Lenny on September 09, 2011, 03:10:59 PM
Hi Guys
I have fished with this lil 'conversion' for ages , works like a bomb .
I like that your bait can move around , and into the holes gutters ect .
An old Struis local have showed me this .
It seems theres only Pros in this one  :hnthnt: , cheaper , limits movement if the seas are big and still  a bit of movement .


All you do when pouring them , on the sides , put short 10mm pieces of wire sticking straight up . once the sinkers is cooler , you can bent them over . this limits the 'roll' of your sinker .
enjoy .
Title: Re: CONE sinker TIP
Post by: mukiwa on September 09, 2011, 04:12:05 PM
nylon grapnel :win:
Title: Re: CONE sinker TIP
Post by: Lenny on September 09, 2011, 04:48:30 PM
A nylon does work , but we fish very light  line , and sometime the Nylon gets so stuck in the sand , when MR Steenbras come out to play , it normally ends in Tears ....  :cry:


you dont have to reply with your vote mate , you can just click the boxes on the top of the thread !
Title: Re: CONE sinker TIP
Post by: Nemesis. on September 09, 2011, 05:14:37 PM
When fishing edibles, the cones and Weed eater grapnels work fine.
But when sliding, heres a trick!
Use a proper Grapnel,8oz and above with at least 2mm wire! Cast, set your sinker, then slide, until the clip reaches the ring.
While the rod is in the rod stand,reel in all the slack, until the rods bends.Set the drag, so that you can pull line off    with a little bit of effort. 
Now we know that Monofilament does stretch a lot, with you're line 120m+ out, and under tension, there is a lot of potential energy stored up in it and in the bending tip of the rod. Once a fish/shark picks up you're bait, and pulls the sinker free, all that built up energy in the line acts like a spring, when it recoils it aids with the hook setting!   
 :hnthnt: Just a lil tip, use it, don't use it :hehe:
Title: Re: CONE sinker TIP
Post by: Lenny on September 09, 2011, 05:37:55 PM
When fishing edibles, the cones and Weed eater grapnels work fine.
But when sliding, heres a trick!
Use a proper Grapnel,8oz and above with at least 2mm wire! Cast, set your sinker, then slide, until the clip reaches the ring.
While the rod is in the rod stand,reel in all the slack, until the rods bends.Set the drag, so that you can pull line off    with a little bit of effort. 
Now we know that Monofilament does stretch a lot, with you're line 120m+ out, and under tension, there is a lot of potential energy stored up in it and in the bending tip of the rod. Once a fish/shark picks up you're bait, and pulls the sinker free, all that built up energy in the line acts like a spring, when it recoils it aids with the hook setting!   
 :hnthnt: Just a lil tip, use it, don't use it :hehe:


thats how we roll in CPT too nemesis  w;k
SimplePortal 2.3.7 © 2008-2026, SimplePortal