| Bait going soft and mushy has always been a nightmare for us anglers especially when on a long trip and its blistering hot. No matter how well you try, the bait always seems to defrost and before you know it, there’s a bloody pool at the bottom of your bait box that spoils the rest of the bait and its frustrating trying to tie a soft sardine when the shad are running and opening your box constantly usually makes it worse. There are a few tricks that an anglers can employ to ensure the bait box is used to its full potential. I hope it makes your day at the beach a little less frustrating. Also not everyone can afford expensive boxes like the safari chiller and so on, so this tip should really help you out. (http://www.kznfishing.com/images/stories/bait_box_tip/baitbox_01.jpg) Alternatively, hijack the Albany truck. I’m joking guys. Don’t steal or hijack anything. These crates are normally all over the place and you can get one for free very easily. An old crate will do.(http://www.kznfishing.com/images/stories/bait_box_tip/baitbox_02.jpg) Then take you chiller or whatever cooler box you have. In this case, I will demonstrate with a 20lt safari chiller.(http://www.kznfishing.com/images/stories/bait_box_tip/baitbox_03.jpg) Open the box and take measurements of the bottom inside the box.(http://www.kznfishing.com/images/stories/bait_box_tip/baitbox_04.jpg) Then place your crate on the floor with the open end facing down. You are interested in the base section of the crate. A chesterfield goes well while you doing this little project(http://www.kznfishing.com/images/stories/bait_box_tip/baitbox_05.jpg) Find your self something to cut with, the plastic is very soft so there’s no need for an angle grinder or anything heavy duty. A normal hacksaw or in this case, one of those multi tools will cut it very quickly.(http://www.kznfishing.com/images/stories/bait_box_tip/baitbox_06.jpg) Cut out the entire base section around the edges and your next step will be cutting it to size.(http://www.kznfishing.com/images/stories/bait_box_tip/baitbox_07.jpg) This is what you will end up with(http://www.kznfishing.com/images/stories/bait_box_tip/baitbox_08.jpg) The piece that you have cut out has 2 sides to it. One side is ridged as shown in the pic.(http://www.kznfishing.com/images/stories/bait_box_tip/baitbox_09.jpg) And then a flat side. When placed in the bait box, the flat side should be facing up. Cut it to size of you chiller and place on the inside, all the way at the bottom.(http://www.kznfishing.com/images/stories/bait_box_tip/baitbox_10.jpg) And this is the final result.(http://www.kznfishing.com/images/stories/bait_box_tip/baitbox_11.jpg) It weighs nothing so don’t be afraid that it’s going to make your bait box heavier. And the good thing about this is that it can be done for free. The idea behind it is that all the defrosting water and blood will drain into the gaps and your bait stays soggy free because it’s above the water. Also, this helps to prevent our coke cans or beers from getting slimy from the defrosting bait. I keep everything in my bait box, drinks, chips included. And its not good when the coke taste like mackerel.So there you go it takes less than 20 minutes to do its FREE and your bait won’t go soggy with blood again. :uarocks |
gonna go steal crate from the corner shop tonyt...lol.... shot for the tip bra