Then the foam shape (curve) was resin'd, but it did not harden or stiffen the foam as much as I was hoping, so I ripped that off and closed the large area on top with aluminium foil and poured PU foam into the underside of the console.
Took the foil off and started "free-hand" shaping the PU foam and got a rough shape. Applied a lightweight body-filler and sanded.
I kept on sanding into the foam below the filler and it became stupid silly applying more filler, sanding and applying filler again and again and .... so I glassed the entire console with a thin weaved mat and then applied filler to the areas I needed to build up and to smooth it out more and that's is where I am at now, pic below.
I plan to glass over when the console if smoothed out, has perfectly mirrored opposing curves and the shape is 110%. Once this is done I will remove all the PU foam from the inside including the thin layer of glass and then bulk it up/reinforce the console from inside, fair and spray outside.
Found a Wonderful product called "peel-ply". Its a breathable fabric that soaks up excess resin and leaves the surfaces ready for either the next layer of glass or for primer/paint, little to no sanding required!!!!!!!
