ULTIMATE ANGLING - the Ultimate SA Fishing website
OFFSHORE ANGLING => Offshore Traces, Rigs and Baits => Topic started by: Capt. Hook on November 08, 2011, 02:09:47 PM
-
The 180 degree rig is one of my favourite double hook rigs; it is ideal for adding strips baits and swims true. For Island Lures and Bullets it is one of the best rigs.
1. Materials:
- 1.5mm stainless steel cable
- 6.4mm & 9.5mm Electrical Heat Shrink (I prefer black, but any colour will work)
- Copper crimps to suit the 1.5mm cable (5 crimps required)
- Stainless Steel Hooks (I have used 10/0 hooks for the tutorial)
2. Cut a length of cable about 2.5 times the length required for the completed rig. The length required will be calculated as follows: Length of Kona skirt from bottom of Kona head, minus half the hook shank length, minus leader loop and crimp. Feed the cable through the eye of the hook and wrap around the shank, bring the cable around the closed side of the hook eye. Bring the loop over and feed back into the hook eye from the opposite side
3. Pull tight and double crimp
-
4. The rig should look like this at this point
5. Cut some 9.5mm heat shrink and slide it over your cable, and feed it onto the hook for later use.
6. Measure your length and put a kink in the cable at your length, perpendicular to your hook eye
-
7. Feed 3 crimps onto your cable
8. Push the cable through your hook, ensuring it will face up.
9. Leave a loop of about 15mm, and double crimp your cable
-
10. Cut the 2 tag ends of the cable so that there is a 1-2mm gap.
11. Place the crimp equally over the gap and crimp only the out sides of the crimp, ensuring that your cable is straight.
12. Rig should look like this, at this point
-
13. Pull the 9.5mm heat shrink to cover the cable wraps over the hook up to the loop, and use a hot air blower to shrink over. You can use a lighter, but I prefer the blower.
14. Put a small piece of 6.4mm heat shrink over the 9.5mm by the hook shank to neaten up.
15. Cut 9.5mm heat shrink to cover the shank of the front hook, apply heat ensuring that all is straight and lined up.
You now have your completed 180 Degree Rig.
-
NIce work FA..............
-
Another sweeeet post Mike!! +cred
-
Link to the single hook and 90 Degree Rig
http://www.ultimateangling.co.za/index.php/topic,7386.new.html (http://www.ultimateangling.co.za/index.php/topic,7386.new.html)
-
FA do you need some braid or something? Nominated for post of the month!
-
Nice, but why double crimps, totally unnecessary if the first one is done correctly. I also found that the hook-up ratio with heat shrink in the last hook is very bad, keep the heat shrink in the pulling hook, but do not put it in the trailing hook.
-
Nice, but why double crimps, totally unnecessary if the first one is done correctly. I also found that the hook-up ratio with heat shrink in the last hook is very bad, keep the heat shrink in the pulling hook, but do not put it in the trailing hook.
Thanks for your valued input Handro.
Just feels safer with double crimps, and they cause no harm, I prefer the heat shrink on the trailing hook as it makes tying strip baits much easier.
-
:+ cred: I hope you get to use them soon on Free Spirit!